Home Up Site Map About Us Español What's New WebMail Contact Us

 

     

 

                     

 

HR Radiant Process Heaters Assemblies

     Consist of one or two rugged tubular heaters mounted in an aluminum housing with a reflector to generate a uniform band of radiant heat to the process. Heated lengths from 16-1/2" to 77" and rating from 600 to 7200 watts are standards.

  • Broad beam - for use as a surface heating medium.
     Break, splash, shockproof metal sheath heating element - extruded
     aluminum housing.
     Absorbed easily by all colors, clear glass, plastics, transparent solids and liquids.
     FAR Infrared - Long invisible radiant wave length (2.5/3 microns).
     Typical work range to 500°F, practical maximum to 900°F.
     For outdoor or hazardous locations specify M7 Terminal enclosure.
  • Design and Installation:
    Normally used perpendicular to direction of work.
     May be ganged together for continuous heat bank.
     Reflector normally located 12" from work. Distance can be varied due to specific
     application requirements.
     Snap-on nickel-plated protective grill available.
     Each unit has at least two sliding steel clamps for mounting that can be positioned
     at any point along the length of the housing. 

 

 

 

 

Band Heaters | Cartridge Heaters | Flexible Heaters | Strip Heaters | Process Air Heaters | Black body Ceramic | Radiant Heaters | Quartz Heaters | Pipe Plug Immersion | Circulation Heaters | Mini-Tubular Heaters | Immersion Heater | Over the side Immersion | Flat Panel Infrared

 

El Paso Heater & Supply Company

 

1450 BESSEMER DR.

El Paso, TX. 79936

Tel: (915) 595-6565  Fax(915)595-6993

 

Design: Trion Solutions

Send mail to sales@elpasoheater.com with questions or comments about this web site.
Copyright © 2009 El Paso Heater & Supply Company
Last modified: 04/23/09